Monte Carlo V6-3.4L VIN E (2000)
1. Install the new idle air control O-ring.
2. Install the idle air control valve in the intake manifold.
NOTE: Refer to Fastener Notice in Service Precautions.
3. Reinstall the idle air control valve (2) attaching screws.
Tighten
Tighten the idle air control valve attaching screws to 3.0 N.m (27 lb in).
4. Connect the electrical connector to the idle air control valve.
5. The PCM will reset the idle air control valve whenever the ignition switch is turned ON, then OFF. Turn the ignition switch ON, then OFF.
6. Start the engine and allow the engine to reach operating temperature.
