Monte Carlo V6-3.4L VIN E (2000)
13.
Follow the instructions displayed on the Techline terminal for hand-held communications set-up screen.
14.
Select Theft Module Re-Learn.
15.
Select program at the summary screen. The terminal will now download information into the Tech 2.
16.
Disconnect the Tech 2 from the Techline terminal.
17.
Re-connect the Tech 2 to the DLC.
18.
At the Scan Tool Main Menu, select Service Programming.
19.
Answer the Tech 2 question.
20.
Select Re-Learn.
21.
The PCM and BCM are now prepared for the Re-Learn procedure to begin.
22.
An internal security timer will now start. The security timer is 10 minutes in duration.
Important:
During this 10 minute period, the scan tool must NOT be disconnected from the vehicle.
Does the Tech 2 display any kind of message telling you to proceed?
23.
Turn the ignition switch to the OFF position.
24.
Start the engine. The engine should start and continue to run.
25.
The Theft Re-Learn procedure is complete. Look for any DTCs which may have been set during this procedure. If codes were set, clear them now.
Remove the Tech 2 from the vehicle.
WITHOUT TECHLINE EQUIPMENT OF ANY KIND
This procedure takes 30 minutes and must not be shortened.
1.
Ensure that the battery is fully charged before starting this procedure.
2.
Turn the ignition switch to the OFF position.
3.
Rotate the ignition switch all the way to the START position then back to the RUN position. The engine will not start.
4.
The security light will come on and stay on for approximately 10 minutes. When the security light goes out, proceed to the next step.
5.
Turn the ignition switch to the OFF position for 5 seconds.
6.
Rotate the ignition switch all the way to the START position then back to the RUN position. The engine will not start.
7.
The security light will come on and stay on for approximately 10 minutes. When the security light goes out, proceed to the next step.
8.
Rotate the ignition switch all the way to the START position then back to the RUN position. The engine will not start.
9.
The security light will come on and stay on for approximately 10 minutes. When the security light goes out, proceed to the next step.
10.
Turn the ignition switch to the OFF position for 5 seconds.
11.
Rotate the ignition switch all the way to the START position then back to the RUN position. The engine will now start.
12.
Using the Tech 2, look for a Clear All Trouble Codes (DTCs).
Warranty Information
For vehicles repaired under warranty, use:
Operation
