Monte Carlo V6-3.4L VIN E (2000)
8. Place the module on a work bench, with the vinyl trim cover facing up and away from the surface.
9. Clear a space on the ground about 1.85 M (6 ft) in diameter for deployment of the module. If possible, use a paved, outdoor location free of
activity. Otherwise use a space free of activity on the shop floor. Verify that you have sufficient ventilation.
10. Clear all loose or flammable objects from the area.
11. Place the module in the center of the space with the vinyl trim cover facing up.
12. Extend the SIR deployment harness and adapter to full length from the module.
13. Place a 12-V minimum, 2-A minimum power source (e.g., a vehicle battery) near the shorted end of the harness.
14. Connect the module (1) to the adapter (2) on the SIR deployment harness (3).
15. Firmly seat the adapter into the module connector.
16. Clear the area of people.
CAUTION: When you are deploying an inflator module for disposal, perform the deployment procedures in the order listed. Failure to
follow the procedures in the order listed may result in personal injury.
