Monte Carlo V6-3.4L VIN E (2000)
5. Short the two SIR deployment harness (1) leads together using one banana plug seated into the other.
6. Connect the appropriate pigtail adapter (2) to the SIR deployment harness (1).
7. Remove the inflatable restraint side impact module.
CAUTION: Refer to Inflator Module Handling And Storage Caution in Service Precautions.
8. Place the module on a work bench, with the vinyl trim cover facing up and away from the surface.
9. Clear a space on the ground about 1.85 M (6 ft) in diameter for deployment of the module. If possible, use a paved, outdoor location free of
activity. Otherwise, use a space free of activity on the shop floor. Verify that you have sufficient ventilation.
10. Clear all loose or flammable objects from the area.
11. Place J 39401-B in the center of the cleared area.
12. Fill the fixture plastic reservoir with water or sand.
IMPORTANT: Securely hand tighten all fasteners prior to deployment.