Monte Carlo V6-3.4L VIN E (2000)
18. Disconnect the inflatable restraint front side impact module (RH) yellow 2-way harness connector located under the front passenger seat.
19. Cut the harness connector out of the vehicle, leaving at least 16 cm (6 in) of wire at the connector.
20. Strip 13 mm (0.5 in) of insulation from each of the connector wire leads.
21. Cut two 4.6-M (15-ft) deployment wires from a multi-strand wire 0.8 sq.mm (18 gage) or thicker. These wires will be used to fabricate the
passenger deployment harness.
22. Strip 13 mm (0.5 in) of insulation from both ends of these wires.
23. Twist together one end from each of the wires in order to short the wires.
24. Twist together one connector wire lead to one deployment wire.
25. Bend flat the twisted connection.
26. Secure and insulate the connection using electrical tape.
