Monte Carlo V6-3.4L VIN E (2000)
5. Remove the inflatable restraint IP module mounting fasteners (3).
6. Remove the inflatable restraint IP module (1) from the cross-car beam (2).
INSTALLATION PROCEDURE
1. Install the inflatable restraint IP module (1) to the cross-car beam (2).
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the inflatable restraint IP module mounting fasteners (3).
Tighten
Tighten fasteners to 10 N.m (89 lb in).
3. Connect the inflatable restraint IP module yellow 2-way wiring harness connector.
