Monte Carlo V6-3.4L VIN E (2000)
15.
Install the carpet retainer along the door opening.
16.
Install the lower seat belt attaching bolt at the carpet.
Tighten
Tighten the bolt to 42 N.m (31 lb ft)
17.
Install the upper quarter trim panel to the body and install the coat hook.
18.
Install the upper shoulder belt to the "B" pillar attaching bolt.
Tighten
Tighten the bolt to 42 N.m (31 lb ft)
19.
Remove the headrest by depressing the buttons in the bezels at the top of the seat back.
20.
Remove the two push-on nuts that attach the guide to the headrest. Discard the push-on nuts and old guide.
21.
Install the new guide on the head rest and install new push-on nuts.
22.
Install the headrest in the seat back.
23.
Route the shoulder belt through the opening in the guide.
24.
Repeat the procedure on the opposite side of the vehicle.
25.
Install the rear seat cushion.
Parts Information
Important:
If replacement of an ORIGINAL PRODUCTION front seat shoulder/lap belt on the above described vehicles is required, then both the driver and
front seat passenger belts must be replaced. In addition, both driver and front seat passenger shoulder belt guides MUST also be replaced. It is NOT
necessary to replace the front seat belt buckles or the rear seat shoulder/lap belts.
Parts are expected to be available from GMSPO, 12/17/99.
Warranty Information
