Monte Carlo V6-3.4L VIN E (2000)
1. Connect the body wiring harnesses to the junction block.
Tighten
Tighten the body wiring harness connector bolts to 7 N.m (62 lb in).
2. Install the junction block tabs to the passenger knee bolster.
3. Install the junction block bolt.
Tighten
Tighten the junction block bolt to 10 N.m (89 lb in).
4. Connect the body wiring harness to the junction block.
5. Install the instrument panel (IP) compartment.
6. Install the RH IP fuse block access opening cover.
7. Connect the negative battery cable.
