Monte Carlo V6-3.4L VIN E (2000)
6. Remove the power steering pressure line (1) from the clamps on the power steering gear.
7. Remove the power steering pressure line (1) from the vehicle.
Installation Procedure
1. Install the power steering pressure line (1) to the vehicle.
2. Install the power steering pressure line (1) to the clamps on the power steering gear.
3. Lower the vehicle.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the power steering pressure line to the power steering gear.
Use a 18 mm crow's foot line wrench with a 2 foot long, 3/8 inch drive extension.
Tighten the power steering pressure line fitting to the power steering gear to 27 Nm (20 ft. lbs.).
5. Install the power steering pressure line to the power steering lines retaining bracket on the engine.
Notice: Refer to Fastener Notice in Service Precautions.
