Monte Carlo V6-3.4L VIN E (2000)
2. Install NEW wheel bearing/hub bolts.
Tighten the NEW wheel bearing/hub bolts to 130 Nm (96 ft. lbs.).
3. Install the wheel drive shaft nut. Refer to Wheel Drive Shaft Replacement in Wheel Drive Shafts.
4. Install the brake rotor. Refer to Brake Rotor Replacement (Front) or Brake Rotor Replacement (Rear) in Brakes and Traction Control.
5. Install the brake caliper bracket with the brake caliper. Refer to Brake Caliper Bracket Replacement (Front) or Brake Caliper Bracket Replacement
(Rear) in Brakes and Traction Control.
Important: Ensure that the connector clip engages the bracket properly.
6. Install the wheel speed sensor electrical connector to the bracket.
7. Connect the wheel speed sensor electrical connector (2).
8. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Wheels, Tires and Alignment.
9. Lower the vehicle.
