Monte Carlo V6-3.4L VIN E (2000)
Wheel Bearing: Service and Repair
Wheel Bearing/Hub Replacement-Rear
Wheel Bearing/Hub Replacement - Rear
Removal Procedure
The wheel bearing in the rear wheel hub is integrated into one unit. The hub is non-serviceable. If the hub and/or bearing is damaged, replace the
complete hub and bearing assembly.
1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
2. Remove the tires and wheels. Refer to Tire and Wheel Removal and Installation in Wheels, Tires and Alignment.
3. Remove the rear caliper and bracket. Refer to Brake Caliper Bracket Replacement (Rear) in Disc Brakes.
4. Remove the brake rotor. Refer to Brake Rotor Replacement (Rear) in Disc Brakes.
5. Disconnect the ABS electrical connector from the wheel speed sensor (1). Refer to Wheel Speed Sensor Replacement (Rear) in Antilock Brakes.
6. Remove the rear wheel hub-to-knuckle bolts.
7. Remove the rear wheel hub and park brake assembly from the knuckle.