Monte Carlo V6-3.4L VIN E (2000)
9. To disassemble, inspect and service the accumulator and 2 - 1 manual servo, refer to Refer to Transmission Unit Repair.
Installation Procedure
1. Install the manual 2-1 band servo (106-116).
2. Install the lube oil pipe (130) to the front differential carrier internal gear lube hole.
3. Position the manual 2-1 band servo cover (104) and accumulator (132) into place.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the manual 2-1 band servo cover bolts (1103).
-
Tighten the manual 2-1 band servo cover bolts (103) to 25 Nm (18 ft. lbs.).
5. Install the accumulator attaching bolts (131).
-
Tighten the accumulator attaching bolts (131) to 12 Nm (106 inch lbs.).