Monte Carlo V6-3.4L VIN E (2000)
Transmission Pressure Test Port: Service and Repair
Removal Procedure
1. Remove the throttle body air inlet duct. Refer to Powertrain Management.
2. Remove the line pressure pipe plug (38) from the automatic transmission.
Installation Procedure
Notice: Refer to Fastener Notice in Service Precautions.
1. Install the line pressure pipe plug (38).
-
Tighten the line pressure pipe plug (38) to 12 Nm (106 inch lbs.).
2. Install the throttle body air inlet duct. Refer to Powertrain Management.