Monte Carlo V6-3.4L VIN E (2000)
6. Remove the wiper motor crank arm from the wiper motor.
6.1. Remove the rubber boot from the wiper motor crank arm.
6.2. Loosen the screw.
6.3. Tap on the screw with a soft-faced mallet while holding up on the wiper motor crank arm until the wiper motor crank arm is loose on wiper
motor.
6.4. Remove the screw and wiper motor crank arm from wiper motor.
7. Remove three screws and wiper motor from wiper drive system module.
8. Remove the shaft seal and the water shield from the wiper motor.
INSTALLATION PROCEDURE
TOOLS REQUIRED
J 39529 Wiper Transmission Installer
