chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Driver/Vehicle Information Display|Service and Repair > < Instruments - DIC Perceived Fuel Economy Settings|Page 7873
Page 2
background image

-

Instantaneous Fuel Economy (IFE)

-

Trip Range

-

Fuel Used

-

Average Speed

COMPASS/TEMPERATURE MODE

This mode displays an 8 point compass heading on the left hand side of the DIC. The compass will display the current vehicle direction relative to one
of 8 compass headings using N, NE, E, SE, S, SW, W, and NW for the readout. The ambient temperature displays on the right hand side of the DIC. If
the ambient temperature is below 3°C (37°F), the temperature reading will toggle between displaying the outside temperature and the word ICE for
two minutes. If the temperature is less than minus 40°F for more than 2 seconds, OC will display. If the temperature is above 140°F for more than 2
seconds
, SC will be displayed. If OC or SC is displayed DTC's will be set. For compass calibration and compass magnetic variation adjustment refer
to Electronic Compass Calibration.

AVERAGE FUEL ECONOMY (AVG)

AFE is calculated as the ratio between the following values:
-

AFE=Distance/Fuel

-

Distance=The accumulated distance since the last AFE reset

-

Fuel=The accumulated fuel consumption since the last AFE reset

You can reset the AFE mode by pressing the RESET button for more than 3 seconds while in this mode. The value of this mode is retained during
ignition OFF.

INSTANTANEOUS FUEL ECONOMY (INST)

Instantaneous fuel economy is calculated as the ratio between the following values:
-

IFE=Distance/Fuel

-

Distance=The accumulated distance since last update

-

Fuel=The accumulated fuel delivered since last update

You cannot reset the IFE mode. The value of this mode is retained during ignition OFF.

TRIP RANGE (RANGE)

Trip Range is calculated between the following values:
-

Trip Range=AFE x Fuel Remaining

-

Fuel Remaining=Fuel sender value of available fuel

You cannot reset the Trip Range mode. The value of this mode is retained during ignition OFF.

FUEL USED

The DIC calculates and displays the total amount of fuel used since the last reset operation.

You can reset the Fuel Used mode by pressing the RESET button for more than 3 seconds while in this mode. The value of this mode is retained
during ignition OFF.

AVERAGE SPEED (AVG SPEED)

Average speed is calculated as the ratio between the following values:
-

Average Speed=Distance/Ignition On

-

Distance=Accumulated distance since last reset

-

Ignition On=Accumulated ignition on time since last reset

Ignition on time is measured from the time that the ignition is turned ON, to the time when the ignition is turned OFF.

You can reset the Average Speed mode by pressing the RESET button for more than 3 seconds while in this mode. The value of this mode is retained
during ignition OFF.

DIMMING CONTROL

Display dimming for the DIC follows the radio dimming characteristics. Upon activation of the parklamps, the display steps from maximum brightness
to dim. While in the dim mode, further dimming is controlled by the PWM Dimming Signal of the IP dimming control. The display goes blank upon
lowest dimming request of the dimming control.

Driver/Vehicle Information Display|Service and Repair > < Instruments - DIC Perceived Fuel Economy Settings|Page 7873