Monte Carlo V6-3.8L SC VIN 1 (2004)
Accessory Delay Module: Scan Tool Testing and Procedures
Scan Tool Data Definitions
SCAN TOOL DATA DEFINITIONS
Software Part Number: Part number of component program or the ECU. Used to determine applicability to vehicle RPO content.
Accessory Switch: Input from ignition switch Accessory circuit. Used to determine power mode. Hot in ACCESSORY and RUN.
Driver Door Open Sw.: Input from the driver door indicating door status (Open-Closed).
Door Ajar Switches: Input showing state of the passenger door(s).
Doors Battery Fd: Indicates completion of the power circuit for the door control functions.
Doors System Gnd: Indicates the completion state of the ground circuit for the door functions.
Electronics Battery Fd: Data indicates the voltage detected by the control module on the power circuit for the module internal devices.
Electronics Battery Fd: Input indicates the completion state of the power circuit for the module internal devices.
Electronics System Gnd: Indicates the completion state of the ground circuit for the module internal devices.
Ignition 0: Input to the control module from the ignition switch indicating the Ignition 0 position. Switch closed (HOT) in ignition switch positions
Unlock, Accessory, Run, Crank.
Ignition 1: Input to the control module from the ignition switch indicating the Ignition 1 position. Switch closed (HOT) in ignition switch positions Run,
Crank.
Inadvertent Power Output: Input indicating the sensed state of the inadvertent power request circuit.
Inadvertent Power Relay: Output indicating the state as commanded by the control module.
Lamp Request: Input telling the control module to initiate inadvertent power management.
Load Management Status: Output indicating the power mode commanded.
Loads Battery Fd: Indicates the completion state of the supply circuit for the high current loads.
Loads System Gnd: Indicates completion state of the ground circuit for the high current loads.
Pass Door Jamb Sw.: Input showing the state of the front passenger door.
RAP Relay: Output indicates state that the control module has commanded.
