Monte Carlo V6-3.8L SC VIN 1 (2004)
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the screws to the front fender liner at the front of the front bumper fascia.
Tighten the front fender liner to fascia screws to 2 N.m (18 lb in).
4. Using new plastic rivits, install the 2 plastic rivits to the front bumper fascia extension corner and front fender liner.
5. Install the lower fascia support.
6. Lower the vehicle.
Fascia Reinforcement - Front Bumper Outer (Monte Carlo)
Fascia Reinforcement - Front Bumper Outer (Monte Carlo)
Tools Required
J 38778 Door Trim Pad Clip Removal
Removal Procedure
1. Remove the front bumper fascia.
2. Remove the front bumper fascia reinforcement outer push-in retainers using J 38778.
3. Remove the front bumper fascia reinforcement outer from the front bumper fascia.
Installation Procedure
