Monte Carlo V6-3.8L SC VIN 1 (2004)
Upper Side Moulding / Trim: Service and Repair
Molding Replacement - Body Side
Tools Required
J 25070 Heat Gun
Removal Procedure
1. Apply tape for alignment marks to aid in the installation of the body side molding.
2. Use tape to protect the mounting surface during removal.
3. When removing a body side molding, heat the body side molding using a J 25070. Apply heat using a circular motion for about 30 seconds.
Notice: Refer to Exterior Trim Emblem Removal Notice in Service Precautions.
4. Use a plastic, flat-bladed tool to remove the body side molding from the panel surface.
5. When replacing a body side molding, remove all adhesive as follows:
*
For body panels use a 3M(TM) Scotch Brite molding adhesive remover disk 3M(TM) P/N 07502 or equivalent.
*
For plastic panels use a lint-free cloth and Varnish Makers and Painters (VMP) naptha or a 50/50 mixture by volume of isopropyl alcohol and
water to remove the adhesive.
Installation Procedure
Important: Apply the body side molding in an environment that is free from dust or other dirt that could come into contact with the
sticky backing. Foreign material may cause improper adhesion.
1. Clean the area where the body side molding will be installed.
Use a lint free cloth and Varnish Makers and Painters (VMP) naptha or a 50/50 mixture by volume of isopropyl alcohol and water to clean the
area.
2. Dry the area thoroughly.
