Monte Carlo V6-3.8L SC VIN 1 (2004)
Trunk / Liftgate Lock Cylinder: Service and Repair
Lock Cylinder Replacement - Rear Compartment Lid (Monte Carlo)
Removal Procedure
1. Open the rear compartment.
2. Remove the lock cylinder retainer from the rear compartment lock cylinder by pulling off.
3. Remove the rear compartment lock cylinder, lock cylinder retainer and gasket from the rear compartment lid.
Installation Procedure
1. Align the lock cylinder shaft to the rear compartment lid latch.
2. Align the rear compartment lock cylinder and gasket to the lock cylinder hole in the rear compartment lid, and press in until fully seated.
