Monte Carlo V6-3.8L SC VIN 1 (2004)
Power Seat Switch: Procedures
Lumbar Switch Replacement
LUMBAR SWITCH REPLACEMENT
REMOVAL PROCEDURE
1. Remove the outer seat cushion trim panel.
2. Remove the screws from the lumbar control switch.
3. Remove the lumbar control switch from the outer seat cushion trim panel.
INSTALLATION PROCEDURE
1. Position the lumbar control switch to the outer seat cushion trim panel.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the screws (1) to the lumbar control switch.
Tighten
Tighten the screws to 2 N.m (18 lb in).
3. Install the outer seat cushion trim panel.
Seat Switch Replacement - Power
SEAT SWITCH REPLACEMENT - POWER
REMOVAL PROCEDURE
1. Remove the front seat cushion outer trim panel.
