Monte Carlo V6-3.8L SC VIN 1 (2004)
1. Install the brake pedal and the bushings.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the brake pedal nut and bolt.
^
Tighten the brake pedal nut and bolt to 40 Nm (30 ft. lbs.).
3. Install the washer and pushrod to the brake pedal.
4. Install the pushrod retaining clip to the brake pedal.
5. Install the wiring harness clips to the bracket.
6. If equipped, install the TCC/cruise release switch.
7. Install the stop lamp switch.
8. Reposition and install the BCM into the retaining bracket.
9. Install the left IP insulator.
