Monte Carlo V6-3.8L SC VIN 1 (2004)
1. Disconnect the negative battery cable.
2. Remove the fuel injector sight shield.
3. Disconnect the intake air temperature (IAT) sensor electrical connector.
4. Remove the air inlet duct from the throttle body.
5. Remove the right and left engine mount struts.
6. Remove the drive belt.
7. Raise and support the vehicle.
8. Remove the right front tire and wheel.
9. Remove the right engine splash shield.
10. Remove the power steering oil cooler pipe brackets from the frame.
11. Remove the A/C compressor and the A/C compressor bracket. DO NOT discharge the A/C system. Secure the compressor.
12. Remove the right exhaust manifold pipe stud nuts from the catalytic converter.
13. Remove the engine mount lower nuts from the frame.
14. Lower the vehicle.
15. Install the engine support fixture.
16. Use the engine support fixture to raise the engine.
