Monte Carlo V6-3.8L SC VIN 1 (2004)
17. Install the right engine splash shield.
18. Install the right front tire and wheel.
19. Lower the vehicle.
20. Remove the engine support fixture.
21. Install the right and left engine mount struts.
22. Install the air inlet duct to the throttle body.
23. Connect the intake air temperature (IAT) sensor electrical connector.
24. Install the drive belt.
25. Install the fuel injector sight shield.
26. Connect the negative battery cable.
Engine Mount Strut Bracket Replacement - Left
Engine Mount Strut Bracket Replacement - Left
Removal Procedure
1. Drain the cooling system.
2. Remove the engine coolant temperature sensor.
3. Remove the engine mount strut at the left engine mount strut bracket.
4. Remove the engine mount strut bracket bolts.
5. Remove the engine mount strut bracket.
Installation Procedure