Monte Carlo V6-3.8L SC VIN 1 (2004)
1. Install the engine mount strut bracket.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the engine mount strut bracket bolts.
-
Tighten the engine mount strut bracket bolts to 50 Nm (37 ft. lbs.).
3. Install the engine mount strut to the left engine mount strut bracket.
4. Install the engine coolant temperature sensor.
-
Tighten the sensor to 25 Nm (18 ft. lbs.).
5. Fill the cooling system.
Upper
Engine Mount Strut Bracket Replacement - Right Upper
Removal Procedure
Caution: Refer to Battery Disconnect Caution in Service Precautions.
1. Disconnect the negative battery cable.
2. Remove the fuel injector sight shield.
3. Remove the right engine mount strut at the upper engine mount strut bracket.