Monte Carlo V6-3.8L SC VIN 1 (2004)
21. Install the new engine front cover seal using J 35354.
22. Tighten the bolt until the crankshaft front oil seal is seated in the engine front cover.
23. Remove the J 35354.
24. Install the crankshaft position sensor shield.
25. Connect the electrical connectors to the following:
-
Oil pressure sensor
-
Crankshaft position (CKP) sensor
-
Camshaft position (CMP) sensor
26. Install the crankshaft balancer.
27. Lower the vehicle.
28. Install the power steering pump and the bolts.
-
Tighten the bolts to 34 Nm (25 ft. lbs.).
29. Remove the engine support fixture.
30. Install the drive belt tensioner.
31. Fill the cooling system.
32. Fill the crankcase with engine oil.
33. Connect the negative battery cable.
34. Inspect for leaks.
35. Perform the CKP system variation learn procedure.
