Monte Carlo V6-3.8L SC VIN 1 (2004)
IMPORTANT: Make certain that the drive plate does not drag against the pulley when the pulley is rotated.
8. Measure the air gap between the pulley and the drive plate. Adjust the shims to achieve a 0.3-0.6 mm (0.012-0.024 in) air gap.
NOTE: Refer to Fastener Notice in Service Precautions.
IMPORTANT: Make certain that the new drive plate bolt has colored adhesive on at least 5 threads.
9. Install the clutch drive plate bolt.
10. Tighten the compressor clutch drive plate bolt.
Use the J 37872 to hold the compressor clutch plate from turning.
Tighten
Tighten the bolt to 12 N.m (106 lb in).
11. Install the compressor.
12. Leak test the fittings using the J 39400-A.
