Monte Carlo V6-3.8L SC VIN 1 (2004)
Fuel Injector: Service and Repair
Fuel Injector Sight Shield Replacement
Fuel Injector Sight Shield Replacement
Removal Procedure
1. Clean the area around the tube/oil fill cap before removing the tube/oil fill cap in order to prevent contaminants from falling into the valve rocker
arm cover opening.
2. Twist counterclockwise to unlock the tube/oil fill cap from the valve rocker arm cover.
3. Lift the fuel injector sight shield up at the front and slide the tab out of the engine bracket.
4. Replace the tube/oil fill cap in the valve rocker arm cover.
Installation Procedure
1. Remove the tube/oil fill cap from the valve rocker arm cover.
2. Insert the tab of the fuel injector sight shield under the engine bracket.
3. Place the hole of the fuel injector sight shield onto the oil fill neck of the valve rocker arm cover.
4. Install the tube/oil fill cap into the valve rocker arm cover and twist clockwise in order to lock the detent on the tube into the notch in the cover.
