Monte Carlo V6-3.8L SC VIN 1 (2004)
4. Slide the new SIR coil (4) onto the steering shaft assembly (2).
IMPORTANT: The new SIR coil will be pre-centered. Do not remove the centering tab from the new SIR coil until the installation is complete.
5. Firmly seat the retaining ring (3) into the groove on the steering shaft assembly (2).
6. Remove and discard the centering tab from the new SIR coil (4).
7. Install the upper shroud (1) and secure by using 2 TORX(r) head screws (2).
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the screws to 1.5 N.m (13 lb in).
8. Install the lower shroud (2) and secure by using 2 TORX(r) head screws (1).
