Monte Carlo V6-3.8L SC VIN 1 (2004)
Knee Diverter: Service and Repair
Knee Bolster Bracket Replacement - Right
KNEE BOLSTER BRACKET REPLACEMENT - RIGHT
REMOVAL PROCEDURE
1. Remove the instrument panel (IP) lower trim panel.
2. Reposition the right IP accessory wiring junction block.
3. Disconnect the wiring harness retainers from the knee bolster bracket.
4. Remove the bracket bolts from the IP passenger knee bolster.
5. Remove the bracket from the IP passenger knee bolster.
INSTALLATION PROCEDURE
1. Align the IP passenger knee bolster bracket to the instrument carrier.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the bracket bolts to the IP passenger knee bolster at the instrument carrier in the sequence shown.
Tighten
Tighten the bracket bolts to 10 N.m (89 lb in).
3. Connect the wiring harness retainers to the IP passenger knee bolster bracket.
4. Install the right IP accessory wiring junction block.
5. Install the IP trim pad.
