Monte Carlo V6-3.8L SC VIN 1 (2004)
Install the J 41718 sunroof timing pins into the left and right sunroof window panel screw holes.
4. Remove the sunroof actuator.
5. Disconnect the electrical connector from the SOPS (3).
6. Remove the SOPS screw (2) from the switch.
7. Hold down on both drive cables, and lift straight up to remove the SOPS from the sunroof module.
Installation Procedure
Important: The new SOPS comes with a position lock pin that is installed on top of the SOPS. This locks the timing gears in place. Do not
remove this pin until after you have installed the SOPS and the actuator.
1. Keeping the position lock pin in the new SOPS, position the SOPS switch over the drive cables and press down.
If the SOPS does not slide into position, the ridges on the drive cable housings will not go into the grooves on the back of the SOPS. Lift each
cable into the SOPS, and press down on the SOPS assembly.
