Monte Carlo V6-3.8L SC VIN 1 (2004)
Turn Signal Switch: Service and Repair
Multifunction Switch Replacement
Multifunction, Turn Signal Switch Replacement
Removal Procedure
Caution: Refer to SIR Caution in Service Precautions.
1. Disable the SIR system.
2. Remove the upper and lower trim covers.
Important: The abrasion sleeve located on the steering column wire harness assembly must be reinstalled. Make note of what connector is coming
out of the abrasion sleeve for installation purposes.
3. Remove the wire harness assembly (1) from the wire harness strap (2).
4. Disconnect the turn signal and multifunction switch assembly connector from the SIR system coil connector.
5. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly out of the bulkhead connector (1).
