Monte Carlo V6-3.8L SC VIN 1 (2004)
Turn Signal Switch: Service and Repair
Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring
Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement
^
Tools Required
-
J 23653-SIR Steering Column Lock Plate Compressor
-
J 42137 Cam Orientation Plate Adapter
Removal Procedure
1. Disconnect the battery negative cable.
Caution: Refer to SIR Caution in Service Precautions.
2. Disable the SIR system.
3. Remove the inflator module.
4. Remove the steering wheel.
5. Remove the SIR coil from the steering column upper shaft.
6. Allow the SIR coil to hang.
7. Remove the wave washer (1) from the steering shaft (2).
8. Compress the shaft lock plate using J23653-SIR and J42137.
9. Remove the bearing retainer (1) from the steering shaft.
10. Remove J23653-S/R and J42137 from the steering shaft.
