Monte Carlo V6-3.8L SC VIN 1 (2004)
5. Remove the positive cable junction block lead nut (1).
6. Remove the positive battery cable (2) from the underhood accessory wiring junction block.
7. Raise and support the vehicle. Refer to vehicle lifting.
8. Remove the front lower air deflector.
9. Remove the transaxle stud nut and the ground wire from the transaxle stud.
10. Remove the positive battery cable nut (8) from the starter motor BAT terminal.
11. Remove the positive battery cable (9) from the starter motor BAT terminal.
12. Unclip and remove the battery cable harness from the retainers (2,3,4).
13. Remove the battery cable harness from the vehicle.
14. Remove the negative battery cable from the wiring harness conduit.
