Monte Carlo V6-3.8L SC VIN 1 (2004)
1. Route the SIR connector through the steering wheel.
2. Align the scribe mark on the steering wheel with the slash mark on the steering shaft.
3. Install the steering wheel.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the steering shaft nut.
^
Tighten the nut to 45 Nm (33 ft. lbs.).
5. Install the Inflatable restraint steering wheel module.
6. Enable the SIR system.
7. Inspect the operation of the following components:
^
The horn
^
The steering wheel
^
The steering wheel controls
