Monte Carlo V6-3.8L SC VIN 1 (2004)
2.2. The J21474-01 washer (2)
2.3. The J21474-01 bearing (3)
2.4. The J 21474-5 (4)
2.5. The J21474-01 puller bolt (5)
3. Tighten the puller bolt (5) until the bushing is installed into the control arm.
4. Disassemble the J21474-01 and J21474-5.
5. Remove the control arm from the vice.
6. Install the lower control arm.
