Monte Carlo V6-3.8L SC VIN 1 (2004)
20.
Lower the vehicle and remove the engine support fixture.
21.
Install the top case side cover bolt.
Tighten
Tighten bolts to 25 N.m (18 lb ft).
22.
Install the transaxle shift cable bracket and shift cable bracket bolts.
Tighten
Tighten the bolts to 30 N.m (22 lb ft).
23.
Install the transaxle shift cable to the shift lever.
24.
Connect the transaxle wiring harness connector.
25.
Install the engine mount struts. Refer to Engine Mount Strut Replacement - Right and Engine Mount Strut Replacement - Left in Engine
Mechanical - 3.8L.
26.
Install the air intake duct and connect the MAF sensor wiring harness.
27.
Install the EVAP hose to EVAP valve.
28.
Install the engine dress cover.
Note:
Refer to Do Not Overfill the Transmission Notice in Cautions and Notices.
29.
Check and fill the transaxle as necessary.
30.
Inspect for fluid leaks.