Monte Carlo V6-3.8L SC VIN 1 (2004)
2. Install the O-ring (59) to the case side cover.
3. Install the case side cover gasket (54).
4. Install the case side cover (53).
Notice: Refer to Fastener Notice in Service precautions.
5. Install the case side cover bolts (56, 57, 58).
Tighten bolts to 25 Nm (18 ft. lbs.).
6. Remove the drain pan from under the transaxle.
7. Install the transaxle mount bracket
8. Install the transaxle mount bracket bolts.
Tighten the bolts to 95 Nm (70 ft. lbs.)
9. Lower the vehicle.
10. Using the engine support fixture raise the engine assembly to the original position
11. Raise the vehicle.
