Monte Carlo V6-3.8L SC VIN 1 (2004)
1. Do NOT install the retaining clip onto the fitting by pushing on the clip.
2. Install the retaining clip into the quick connect fitting by using your thumb and forefinger. Insert the retaining clip into one of the three fitting
recesses. Ensure that the retaining clip is engaged in all 3 slots.
3. With one end of the retaining clip engaged in the connector fitting slot, use your thumb in order to rotate the retaining clip around the connector
fitting, until the retaining clip snaps into place.
4. Ensure that the 3 retaining clip ears are seen from inside the fitting and that the retaining clip moves freely in the fitting slots.
Important: A distinct snap should be heard when assembling the cooler line to the quick connect fitting. To ensure the cooler line is fully inserted
into the quick connect fitting, give the cooler line a gentle pull.
Do not use the plastic cap in order to install the cooler line into the fitting.
