Monte Carlo V6-3.8L SC VIN 1 (2004)
Windshield Washer Hose: Service and Repair
HOSE REPLACEMENT - WINDSHIELD WASHER
REMOVAL PROCEDURE
1. Open the hood.
2. Remove the right front fender liner.
3. Disconnect the washer hose from the washer pump.
4. Lower the Vehicle.
5. Disconnect the washer hose from the wiper arms.
6. Disconnect the washer hose from the air inlet grille panel.
7. Pull the washer pump hose out from along side the right front inner fender and into the engine compartment.
8. Remove the washer hose from the vehicle.
INSTALLATION PROCEDURE
