Monte Carlo V6-3.8L SC VIN 1 (2004)
Wiper Motor: Service and Repair
Wiper Motor Replacement
WIPER MOTOR REPLACEMENT
REMOVAL PROCEDURE
1. Remove the air inlet grille panel.
2. Remove the wiper motor crank arm.
3. Remove the wiper drive system module.
4. Remove the wiper motor screws.
5. Remove the wiper motor from the wiper drive system module.
6. Remove the shaft seal and the water shield from the wiper motor.
INSTALLATION PROCEDURE
1. Install the water shield and shaft seal onto the wiper motor.
2. Position the wiper motor to the wiper drive system module.
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the wiper motor screws.
Tighten
Tighten the screws to 7 N.m (62 lb in).
4. Install the wiper drive system module.
