Monte Carlo V6-3.8L VIN K (1998)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
Brake Modulator Replacement (B)
REMOVAL PROCEDURE
1. Remove the gear cover (3).
2. Remove the brake motor pack Antilock Brake System (1) (ABS)
3. Remove two ABS brake modulator to master cylinder banjo bolts (2).
4. Separate the brake modulator (6) from the master cylinder (8).
5. Remove two transfer tubes (7) with O-rings from the master cylinder (8) or the ABS brake modulator (6).
6. Remove banjo bolt O-rings from the master cylinder (8) and the ABS brake modulator (6).
INSTALLATION PROCEDURE
IMPORTANT: When replacing the ABS brake modulator, install the three gears in the same location on the replacement brake modulator.
