Monte Carlo V6-3.8L VIN K (1998)
7. Lubricate the bolt and the bolt boot. Use silicone grease.
NOTICE: Refer to Fastener Notice in Cautions and Notices.
8. Install the upper caliper bolt.
^
Tighten the caliper bolt to 44 Nm (32 ft. lbs.).
9. Remove the wheel nuts securing the rotor to the hub and bearing.
10. Install the tires and the wheels. Align the previous marks on the wheel, hub, and bearing.
11. Lower the vehicle.
12. Fill the master cylinder to the proper level with clean brake fluid.
13. Apply approximately 778 N (175 lb) of force three times to the brake pedal in order to seat the pads against the rotor.
14. Burnish the pads and the rotors.
