Monte Carlo V6-3.8L VIN K (1998)
15. Lubricate the piston OD with clean brake fluid.
16. Install the piston (3) and the boot (4) into the bore of the caliper (2). Complete the following steps:
16.1. Start threading the piston into the caliper bore by hand.
16.2. Screw the piston into the caliper bore using a spanner-type tool in the slots (1) at the end of the piston.
17. Install the boot ring (8).
17.1.Ensure that the outside edge of the piston boot (7) is seated smoothly in the counterbore of the caliper body (9).
17.2.Manipulate the boot ring (8) into the groove near the open end of the caliper bore. Do not pinch the piston boot between the boot ring and the
caliper body.
17.3.Lift the inner edge of the piston boot next to the piston. Press out any trapped air. Ensure that the boot lies flat.
18. Install the caliper.
