Monte Carlo V6-3.8L VIN K (1998)
10. Remove the balance shaft driven gear bolt.
11. Remove the balance shaft driven gear,
12. Clean and inspect all of the components for wear and/or damage. Refer to Timing Chain and Sprockets Clean and Inspect.
13. If the pistons have been moved in the engine, use the following procedure:
13.1.
Turn the crankshaft so that the number one piston is at top dead center.
13.2.
Turn the camshaft so that, with the sprocket temporarily installed, the timing mark is straight down.
INSTALLATION PROCEDURE
^
Tools Required
-
J36660 Torque Angle Meter
1. Install the balance shaft driven gear.
NOTICE: Refer to Fastener Notice in Service Precautions,
NOTICE: This bolt is designed to permanently stretch when tightened. The correct part number fastener must be used to replace this type of
fastener. Do not use a bolt that is stronger in this application. If the correct bolt is not used, the parts will not be tightened correctly. The system or
the components may be damaged.
2. Install the balance shaft driven gear bolt.
^
Tighten the balance shaft gear driven bolt to 22 Nm (16 ft. lbs.). Use the J36660 to tighten the bolt an additional 70 degrees.
3. Install the camshaft thrust plate.
4. Install the camshaft thrust plate bolts.
