Monte Carlo V6-3.8L VIN K (1998)
7. Install the fuel injector sight shield bracket to the exhaust manifold studs.
8. Install the fuel injector sight shield bracket nuts.
^
Tighten the fuel injector sight shield bracket nuts to 30 Nm (22 ft. lbs.).
9. Install the right (rear) spark plug wires. Refer to Spark Plug Wire Harness Replacement (3800 L36 (VIN K)) in Starting and Charging.
10. Install the fuel injector sight shield. Refer to Engine Cover Replacement See: Service and Repair
11. Connect the battery ground (negative) cable. Refer to Battery Negative Cable Disconnect/Connect in Starting and Charging.
12. Check for proper fluid levels.
13. Check for oil leaks.
