Monte Carlo V6-3.8L VIN K (1998)
Ignition Cable: Service and Repair
Tools Required
^
J 38491 Spark Plug Heat Shield Removal Tool
REMOVAL PROCEDURE
1. Turn OFF the ignition switch.
2. Remove the fuel injector sight shield. Refer to Engine Cover Replacement See: Service and Repair.
CAUTION: Twist the spark plug boot one-half turn in order to release the boot. Pull on the spark plug boot only. Do not pull on the spark plug
wire or the wire could be damaged.
3. Note the position of the spark plug wires before removing the wires. See the callouts for coil-to-cylinder combinations.
NOTES:
-
Gently pry the heat shield up from spark plugs using the J 38491.
-
Remove the spark plug wires form the spark plugs at the rear of the engine.
4. Remove the spark plug wires from the spark plugs at the front of the engine. See the callouts for the coil-to-cylinder combinations.
