Monte Carlo V6-3.8L VIN K (1998)
1. Install the exhaust muffler inlet pipe clamp to the end of the exhaust muffler. Do not tighten the clamp.
2. Install the exhaust muffler.
3. Install the exhaust muffler rear hanger insulators to the exhaust muffler.
4. Tighten the exhaust muffler inlet pipe clamp nuts.
^
Tighten the exhaust muffler inlet pipe clamp nuts to 50 Nm (37 ft. lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
5. Lower the vehicle.
