Monte Carlo V6-3.8L VIN K (1998)
Description
1. Install the driver seat retractor side belt (2) to the vehicle.
2. Install the belt retractor (5) into the T-slot in the lower quarter finish panel (4).
NOTICE: Refer to Fastener Notice in Service Precautions.
3. Use the J29843-9 in order to install the seat belt retractor bolt (2).
Tighten
Tighten the seat belt retractor bolt to 42 N.m (31 lb ft).
Description
4. Route the seat belt (1) through the slot in the quarter lower trim finish panel (4).
5. Install the bushing (3) at the lower seat belt anchor.
6. Use the J 29843-9 in order to install the lower seat belt anchor plate bolt.
Tighten
Tighten the lower seat belt anchor plate bolt to 42 N.m (31 lb ft).
7. Slide the sleeve downward in order to cover the seat belt anchor bolt.
