Monte Carlo V6-3.8L VIN K (1998)
Seal Installation
3. Stub shaft bearing annulus assembly (21) onto valve stub shaft.
4. Seal protector J 29810 onto valve stub shaft.
5. Apply a small quantity of grease between seals (20) and (18).
-
Stub shaft seal (20) and stub shaft dust seal (18) over protector and into gear assembly (30).
6. Retaining ring (17) into groove in gear assembly (30).
7. Lubricate stub shaft and dust seal area with grease.
Rack Bearing Installation And Adjustment
8. Coat rack bearing, adjuster spring and adjuster plug with lithium base grease and install in gear assembly (30).
Adjust
With rack centered in the gear assembly (30), turn adjuster plug clockwise until it bottoms in the gear assembly, then back off 50° to 70 °