Monte Carlo V6-3.8L VIN K (1998)
Hydraulic Thermo Valve: Service and Repair
4T65-E Automatic Transaxle
REMOVAL PROCEDURE
1. Remove the oil pan. Refer to Oil Pan Replacement.
2. Remove the thermo element pins and washers (120).
3. Remove the thermo element (121) and the thermo element plate (122).
INSTALLATION PROCEDURE
^
Tools Required
-
J 34094-A Thermo Element Height Gage
1. Use the J 34094-A to set the thermo pin (123).
2. Install the new thermo element plate (122).
3. Install the pin and washer (120).
4. Use the J 34094-A to set the height of the pin and washer (120) furthest from the accumulator.
5. Use the J 34094-A to set the height of the second pin and washer (120).
